HVAC Repair in Russellville, AR
Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Pope County will get in touch.
Tell us about the job
It takes about a minute.
Russellville runs its system almost year round
Heat runs October through April here, then cooling takes over for May through September. That leaves only a short stretch when the system sits idle, so the parts that start it up and shut it down get worked hard both seasons.
Winter nights average 30°F, cold enough that the furnace cycles on and off through the night to hold the house steady. Summer afternoons average 89°F, and the air conditioner answers with long runs to keep up. Most homes here heat with electricity, so when storms knock out power, the heat goes with it. Pope County has seen 80 damaging wind events and 3 winter storms over the past ten years, and statewide almost a quarter of households went at least a day without power in 2024. A system that loses power and comes back on cold has to work harder to catch up, and that is when a weak part tends to fail.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 30°F
- the average winter night it heats against
- 89°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Arkansas requires HVAC contractors to hold a state license.
Arkansas licenses HVAC contractors, which means the state tested the contractor and keeps a record of who holds a license. The license covers the contractor, not each individual job. Counties and cities in Arkansas cannot require their own HVAC license on top of that, so the state license is the one that applies here in Pope County.
For a repair to a heating and cooling system, that license is what stands behind the person doing the work. If the job involves gas, a bad connection is the dangerous part of it, and the contractor working on it is the one the state license accounts for.
Source: Arkansas Department of Labor and Licensing
- Why is my heat not working?
- Most often the thermostat, the igniter, or the power to the furnace is the problem. If the screen is blank, check the breaker first, since that costs you nothing to rule out. A furnace that tries to start and shuts off again is usually failing on the igniter or the flame sensor. With winter nights here averaging 30°F, a furnace that will not stay lit needs a contractor soon, not a guess and a wait.
- Why is my system running but not cooling the house?
- The blower is moving air but something between the air and the cold is missing. A dirty filter chokes airflow across the coil, and a coil that gets too little air can ice over and stop cooling altogether. Low refrigerant does the same thing from the other side, and that only gets fixed by a licensed contractor, since Arkansas requires one to handle it. Check the filter first. If it is clean and the air still feels warm, the problem is inside the system.
- What can I check before calling for HVAC repair?
- Check the thermostat batteries and the setting, then check the breaker for the unit. Look at the filter and swap it if it is gray or clogged, since a blocked filter can cause both weak heat and weak cooling. Outside, make sure nothing is blocking the outdoor unit or the vent hood. If those all check out and the system still is not doing its job, that points to something a contractor needs to diagnose.