HVAC Repair in Batesville, AR
Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Independence County will get in touch.
Tell us about the job
It takes about a minute.
Twelve months of work, with nothing off season
Your system in Batesville does not get a break. Heat runs October through April, then cooling takes over for May through September. That is every month of the year with the furnace or the AC doing something.
Winter nights averaging 31°F mean the burner cycles on and off for hours at a stretch, and summer afternoons near 89°F push the compressor just as hard the other way. 55.8% of homes here heat with electricity, so when a storm knocks out power, the heat goes with it. Arkansas saw 24% of households lose power for at least a day in 2024, and this area has logged 11 winter storms and 32 damaging wind events over the past ten years. A system already worn from running most of the year has less to give when the power comes back on.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 31°F
- the average winter night it heats against
- 89°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Arkansas requires HVAC contractors to hold a state license.
The license belongs to the contractor, not to any single job. Arkansas tested that contractor and keeps a record of them before they can take on work under that license. Counties and cities in Arkansas cannot add their own HVAC license on top of it, so the same state license applies whether the work is in a small town or Batesville.
For a repair on your heating and cooling system, that state license is what stands behind the person doing the work. It covers the contractor generally, not this specific job, so the license tells you the contractor has been tested and is on record with the state, not that this particular repair was checked by anyone.
Source: Arkansas Department of Labor and Licensing
- Why is my heat not working?
- Most often it is the thermostat, the igniter, or the flame sensor. Check the thermostat first. Make sure it is set to heat and the temperature is above room temperature, and swap the batteries if the display looks blank or dim. If the furnace tries to start and shuts off, or does not respond at all, that points to the igniter or flame sensor, and a contractor licensed in Arkansas will need to replace it. With winter nights here averaging 31°F, do not wait on this one.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust chokes off airflow across the coil, and the coil can ice over, which stops it from pulling heat out of the air even though the fan keeps blowing. Check the outdoor unit too. If it is packed with grass clippings, leaves, or debris, it cannot release the heat it is pulling from inside the house. If the filter is clean and the outdoor unit is clear and you still have no cool air, the refrigerant charge or the compressor likely needs a contractor to look at it.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Confirm it is set to the mode you want, the temperature is actually calling for heat or cooling, and the batteries are good. Next check the air filter and replace it if it looks gray or clogged. Restricted airflow causes both heating and cooling problems. Check the breaker panel for a tripped breaker, and if it is an outdoor condenser unit, make sure nothing is blocking it. If the system still is not working after that, a licensed contractor will need to diagnose it.