Furnace Repair in Batesville, AR
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Independence County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, and storms that knock out power
Batesville needs heat from October through April, seven months of the year. On winter nights averaging 31°F, the furnace cycles on and off for hours at a time, and every one of those starts puts wear on the igniter. Over a winter that adds up, and a worn igniter is a common reason a furnace stops lighting.
55.8% of homes here heat with electricity, so the furnace depends on the power staying on. Independence County has seen 11 winter storms and 32 damaging wind events over the past ten years, and in 2024 nearly a quarter of Arkansas households lost power for 24 hours or more. When the power drops in the middle of a cold snap, the furnace stops with it, whether or not anything is actually wrong with it.
- 7 months
- October through April, your furnace is on duty
- 31°F
- the average winter night it heats against
- 11 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
Arkansas requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued job by job, so it is the business or individual you hire that is tested and on record with the state, not the specific repair. Since Arkansas licenses at the state level, cities and counties in Independence County are not allowed to layer on their own HVAC license requirement, so the same standard applies here as anywhere else in the state.
For a furnace repair, that license is what stands behind the person working on your gas line and connections. A loose or badly sealed gas fitting is the dangerous part of this job, and the state license is the accountability that exists for the contractor doing that work.
Source: Arkansas Department of Labor and Licensing
- Why won't my furnace turn on?
- The most common reason is the thermostat isn't calling for heat the way you think it is, or power to the furnace has been cut off somewhere. Check that the thermostat is set to heat and the temperature is above room temperature, then check the furnace switch and the breaker. If those are fine, the igniter or the flame sensor may have failed, and a furnace won't run without either one working. With winter lows here averaging 31°F, it's worth having this looked at quickly rather than waiting it out.
- Why is my furnace blowing cold air?
- If air is moving but it isn't warm, the burners likely aren't lighting even though the blower is running. This points to an ignition problem, a bad flame sensor, or the gas supply being interrupted. It can also mean the furnace is stuck running the fan only, without ever calling for heat. Either way, the blower working while the burners don't is the sign to look for.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit is almost always the thermocouple, the small sensor that tells the gas valve the pilot is burning. When it wears out or sits out of position, it shuts the gas off even though the flame is there. A draft blowing across the pilot or a dirty pilot orifice can cause the same thing. A standing pilot doesn't use electricity, so power outages aren't the cause here, and a licensed contractor can tell which of these it is.