Furnace Installation in Heber Springs, AR
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Cleburne County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat in Cleburne County
From October through April, your furnace is the thing standing between your house and a 31°F night. That's seven months of the year it has to work, not just a few cold snaps. A new furnace here needs to hold up to that stretch, year after year.
Most homes in Arkansas heat with electricity, but if you're installing a gas furnace, federal rules require it to reach at least 80 percent AFUE. Storms are part of the picture too. Cleburne County has logged 10 winter storms and 24 damaging wind events over the past ten years, and in 2024 nearly a quarter of Arkansas households lost power for at least a day. A furnace installed to code and installed right is one less thing to worry about when the weather turns.
- 7 months
- October through April, your furnace is on duty
- 31°F
- the average winter night it heats against
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
Arkansas requires HVAC contractors to hold a state license.
The license belongs to the contractor, not to this one job, so it stays valid across every furnace they install anywhere in the state. Arkansas also keeps that authority to itself. Cities and counties in Cleburne County cannot layer their own HVAC licensing on top of it, so the state credential is the one that applies here.
For a furnace installation, that license tells you the contractor was tested and is on record with the state. It does not replace the local building department's role. Most cities and counties still require a permit for a furnace replacement, along with an inspection once the work is done, and that inspection is what checks the gas connections and venting on the finished job.
Source: Arkansas Department of Labor and Licensing
- What size furnace does my house need?
- There's no single number that works for every house. It comes down to your square footage, your insulation, your ceiling height, and how many windows you have facing north. A contractor will run a load calculation on your actual house rather than guess off a chart, because a furnace that's too big cycles on and off and never runs long enough to heat evenly, and one that's too small runs constantly and still can't keep up on the coldest nights.
- How do I know it's time to replace my furnace?
- Look at how often it needs a repair call and how it's keeping up with the cold. If you're calling for the same problem more than once a season, or it's running longer than it used to just to hold the temperature, that's a furnace telling you it's tired. Winter nights here average 31°F, and homes need heat from October through April, so a furnace on its way out gets tested for most of the year, not just a few cold snaps. A contractor can check the heat exchanger and the burners and tell you whether what you're seeing is normal wear or the start of the end.
- Is a high-efficiency furnace worth it?
- It depends on how long you plan to stay in the house and what you're paying to heat it now. Every new non-weatherized gas furnace sold today has to hit at least 80 percent AFUE by law, and high-efficiency models go higher than that, meaning less fuel wasted out the flue. With 59.3 percent of homes here heating with electricity, a lot of houses are on electric furnaces or heat pumps rather than gas, and the efficiency math works differently for those. A contractor can look at your current system and your utility bills and tell you what the numbers actually look like for your house.