HVAC Installation in Malvern, AR
A new system here will heat from November through March and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Hot Spring County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of the year, your system is working
Malvern gets five months of heat and five months of cooling, back to back. From November through March your furnace runs against winter nights that average 33°F. From May through September your air conditioner works against afternoons that average 91°F. Only two months a year ask nothing of either system.
Storms are part of the picture too. Hot Spring County has recorded 9 winter storms and 45 damaging wind events over the past ten years, and in 2024 nearly a quarter of Arkansas households lost power for at least a day. A furnace or air conditioner that comes back on by itself once power returns matters here. So does a system sized to handle a 33°F night or a 91°F afternoon without strain.
- 5 months
- November through March, your system heats
- 5 months
- May through September, it cools
- 33°F
- the average winter night it heats against
- 91°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Arkansas requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued for each job, so it covers the business doing the work rather than any single installation. Arkansas also keeps cities and counties out of the licensing business, so the same state license applies whether the job is in Malvern or anywhere else in Hot Spring County.
For a heating and cooling system installation, that license is what stands behind the work. On top of it, most cities and counties still require a permit for a job like this, with an inspection once it's done, so the installation gets a second, separate check from the local building office.
Source: Arkansas Department of Labor and Licensing
- When should I replace my HVAC system?
- Replace your system when it's breaking down more than once a season or a contractor tells you the repair costs more than the unit is worth. An aging furnace or air conditioner is a good candidate, especially since homes here need heat or cooling 10 months out of the year with little downtime for a failing system to rest. If your energy bills have crept up with no other explanation, that's often the equipment losing efficiency as it ages.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together usually makes sense. A furnace and air conditioner installed at the same time are matched to work together, and it's simpler for a contractor to set up the system once rather than come back later for the other unit. That said, if one is much newer than the other, there's no reason to replace something that still has years left in it. A contractor can look at both and tell you whether they're close enough in age and condition to justify doing it at once.
- What happens during an HVAC installation?
- A contractor removes the old furnace or air conditioner, then sets the new unit in place and connects it to your ductwork, gas line or electrical circuit, and the vent or drain lines it needs. For a furnace, that includes checking the vent hood for a proper seal. For an air conditioner, it means connecting the refrigerant lines and verifying the charge. Once everything is connected, the contractor runs the system through its paces and checks that it's heating or cooling the way it should before calling the job done.