Furnace Repair in Berryville, AR
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Carroll County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat calls on your furnace here
From October through April your furnace is what stands between you and a 28°F night. That kind of cold means long, frequent burner cycles, and every cycle puts a little more wear on the igniter and the parts that get the burner lit. When one of those finally gives out, the furnace won't fire, and you notice fast because there are seven months a year when you need it to.
Berryville has also seen its share of winter storms and high wind, ten winter storms and 35 damaging wind events over the past ten years. Storms like that knock out power, and in 2024, 24% of Arkansas households lost power for a full day or more. Just over half the homes in the area heat with electricity, so when the power goes, the furnace goes with it, and getting it back running is the first step to getting warm again.
- 7 months
- October through April, your furnace is on duty
- 28°F
- the average winter night it heats against
- 10 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
Arkansas requires HVAC contractors to hold a state license.
Arkansas licenses HVAC contractors. The state tests and records who holds that license, and it covers the contractor rather than this one furnace repair. Carroll County and its cities cannot layer their own HVAC license requirement on top of it, since Arkansas keeps that authority to itself.
That means the state license is what stands behind whoever repairs this furnace, with no separate county license standing alongside it. A furnace repair means gas connections are part of the job, and getting them right is the part that matters most. In Arkansas, the license held by the contractor is what accounts for that work being done by someone the state has tested and put on record.
Source: Arkansas Department of Labor and Licensing
- Why won't my furnace turn on?
- Most often it's the thermostat, the power supply, or the igniter. Check that the thermostat is set to heat and the temperature is above room temperature, and check the breaker for the furnace. If those are fine, the igniter may have failed, or a safety switch has shut the system down because of a bigger problem like a clogged filter or a blocked vent. A licensed contractor can test each part and find which one it is.
- Why is my furnace blowing cold air?
- If air is moving but not warm, the burners likely aren't lighting even though the blower is running. That can mean a bad igniter, a dirty flame sensor, or the gas valve not opening. It can also mean the furnace is in a startup delay, where the blower runs for a few seconds before the burners fire, and if the burners never catch you'll feel only cold air the whole time. A contractor licensed in Arkansas can check the ignition system directly.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit is usually the thermocouple, the small sensor that tells the gas valve the flame is burning. If it's worn out or coated with soot, it reads no flame even when one is there, and the valve shuts off the gas. A draft blowing across the pilot or a partly closed gas valve can cause the same thing. Since this involves the gas supply, have a licensed HVAC contractor check it rather than relighting it repeatedly.