Macro shot of ice crystal formations growing upward along a frozen windowpane, with snowfall and blurred trees visible in the background.

HVAC Installation in Paragould, AR

A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Greene County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gas furnace and sheet-metal air handler unit installed in an unfinished concrete basement.

A system that works almost every month here

Paragould asks for heat from October through April and cooling from May through September. That is 12 months out of 12 where your system is either one or the other. Winter nights average 31°F, cold enough that a furnace or heat pump runs often through those months. Summer afternoons average 89°F, and the AC side has to answer that heat for five straight months.

Most homes here heat with electricity, so a new system has to handle both jobs well, not just one. Greene County has also seen 12 winter storms and 42 damaging wind events over the past ten years, and close to a quarter of Arkansas households lost power for at least a day in 2024. A new furnace or air conditioner installed here should be sized and set up for what the year actually does, not just for a mild stretch in between.

7 months
October through April, your system heats
5 months
May through September, it cools
31°F
the average winter night it heats against
89°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing interior rooms, ductwork, and a dark furnace unit with a tall flue pipe rising past the shingled roof.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

Arkansas requires HVAC contractors to hold a state license.

The license belongs to the contractor, not to your job specifically. Arkansas tests and records the contractor once, and that record follows them from house to house. Cities and counties in Greene County cannot layer on their own HVAC license on top of that, so the state's license is the credential that applies here, full stop.

For a heating and cooling installation, that license is what stands behind the person doing the work, but the job itself still gets checked separately. Replacing a furnace, air conditioner or heat pump typically needs a permit from the local building office, with an inspection once the installation is done. That inspection is what confirms the gas and electrical connections were done right and the unit was set up to code, and it happens apart from anything the state license covers.

Source: Arkansas Department of Labor and Licensing

When should I replace my HVAC system?
Look at how often it breaks down and how old it's getting. Homes here need heat or cooling all year, October through April for heat and May through September for cooling, so a system nearing the end of its life gets no real break to recover between seasons. Frequent repair calls, rising energy bills, or a repair quote that starts to rival the cost of a new system are signs it's time to replace rather than wait for it to fail on a 31°F night or an 89°F afternoon. A contractor can look at the age and condition of your system and tell you where it stands.
Should I replace my furnace and air conditioner at the same time?
If they're close in age, replacing both together often makes sense, but it depends on the condition of each one. A furnace and air conditioner installed at the same time tend to wear down together, so if one is failing, the other may not be far behind. They also share the same ductwork and, in many systems, the same blower, so matching the two units lets a contractor size the whole system correctly. If one unit is much newer than the other, a contractor can look at both and tell you whether replacing just the failing one makes sense.
What happens during an HVAC installation?
A contractor first removes the old furnace or air conditioner and disconnects it from the ductwork, gas line, electrical, and refrigerant lines as needed. The new equipment gets set in place and connected the same way, then the contractor checks refrigerant charge, gas pressure, and airflow to make sure everything matches the manufacturer's specs. Once it's running, they test the thermostat and cycle the system through heating and cooling to confirm it responds correctly. Arkansas requires the contractor doing this work to hold a state HVAC license.